Energy Audit Checklist
Lighting - Operation
	Use automated lighting controls.
	Utilize photocells for all-night outdoor lighting.
	Use timers in parking lots and restricted-access areas.
	Utilize dimming controls to take advantage of daylighting.
	Use motion sensors for low-traffic areas.
	Always de-energize ballasts that are not in use.
	Reduce lighting to minimum acceptable level for safety/security in: hallways, restrooms, storeroom and coolers.

Recommended Lighting Levels for Retail Stores
Store Area	Average Footcandles
High value/intricate merchandise	100
Fitting rooms	75
Cosmetics/pharmacy	75
General merchandise	50
Offices	45
Stockrooms	30
Lounges	20

Lighting - Maintenance
	Clean lamps and fixtures for maximum illumination.
	Repair/replace broken fixtures.
	Replace non-working lamps with the lowest wattage available while maintaining lumen output.
	Develop and implement a lamp upgrade program to energy efficient lighting (T-8, compact fluorescent, etc.).
	Add reflectors to existing lighting.
	Label panels and switches so lighting can be monitored and controls can be accessed.

Lighting - Procedures
	Turn off lights not being used.
	Use task lighting in place of area lighting where possible.
	Open drapes/blinds and use natural lighting when possible.
	Designate and light only specific parking areas for use.
	Use decorative lighting and electrical signs only during high-traffic hours.

Heating, Ventilation and Air Conditioning (HVAC) - Operation
	Winter recommended temperature, 65°F.
	Winter recommended setback temperature, 55°F.
	Summer recommended temperature setting, 80 °F with 55% relative humidity.
	Monitor make up air ventilation (15 cfm/person required).
	Avoid heating and cooling at the same time.
	Use timers for start/stop cycles.
	Utilize programmable thermostats to maximize comfort and efficiency.

Heating, Ventilation and Air Conditioning (HVAC) - Maintenance
	Replace furnace filters on a montly or bi-monthly schedule.
	Allow free airflow to and from registers.
	Insulate hot water heater(s) and pipes, and ductwork located in unconditioned areas.
	Cover and lock thermostats and ventilation controls to prevent unauthorized adjustments.
	Check for unusual noise, vibration and decrease in performance or compressors/motors.
	Seal ductwork leaks.
	Inspect/clean condenser coils.
	Clean and disinfect condensate drain pans.
	Set up monthly/bi-monthly maintenance contract.

Heating, Ventilation and Air Conditioning (HVAC) - Procedures
	Minimize heating and cooling in unoccupied, low-traffic areas or when building is not in use.
	Adjust building temperature by season; lower in winter and higher in summer.
	Utilize ceiling fans whenever possible.
	Close doors to outside and unheated or uncooled areas.
	Use exhaust ventilation only when required.
	If fossil fuels are present, test operation of carbon monoxide (CO) detectors monthly.

Building Envelope
	Check and verify insulation levels.
	Fill in outside air leaks with a low expanding foam.
	Replace cracked or missing window and door caulking.
	Install solar film or blinds for windows with east, west or south exposure.
	Replace cracked or missing weather-stripping.

Contact your local NPPD Technical Solutions Consultant for additional information or to identify energy conservation opportunities in greater detail.